direwolf で 9600bps を試す #12017/01/14 23:02

9600bpsのパケット受信をTNCからsoundmodemに切り替え中。

愛用のsoundmodem:direwolfはサウンドカードを選ぶようだ。自慢のRigBlaster Advantageでは 全くデコードしない のでガッカリした。というか,原因に気付くのに時間がかかった。RTFM!

推奨サウンドカードとして,作者はCM108を使用したサウンドカードを挙げているが,手持ちに無いので、内蔵サウンドカード(HD Audio)で試す。

性能は(定性的だが)TNCより良い感じ。でも,起動時のメッセージが気になる。サンプリングレートを上げる必要があるみたい。MixWで9k6 G3RUHを試した時でもサンプリングレートは22.05kHzだったのに,とか思った。

% direwolf
...
Channel 0: 9600 baud, K9NG/G3RUH, +, 44100 sample rate x 2.
The ratio of audio samples per sec (44100) to data rate in baud (9600) is 4.6
This is on the low side for best performance.  Can you use a higher sample rate?

サンプリングレートを48kHzに設定すると,苦言は無くなった。でもサンプリングレートを更に上げた方が良いみたい。

% direwolf -r 48000
...
Channel 0: 9600 baud, K9NG/G3RUH, +, 48000 sample rate x 2.
The ratio of audio samples per sec (48000) to data rate in baud (9600) is 5.0
Increasing the sample rate should improve decoder performance. 

サンプリングレートを96kHzに設定して,お褒めの言葉を頂きました。

% direwolf -r 96000
...
Channel 0: 9600 baud, K9NG/G3RUH, +, 96000 sample rate x 2.
The ratio of audio samples per sec (96000) to data rate in baud (9600) is 10.0
This is a suitable ratio for good performance.

評価はこれから...

本日の衛星:XW-2B, XW-2Cで交信。BISONSAT, GRIFEX, LILACSAT-2, STRAND-1, PSAT, BUGSAT-1をデコード。BY70-1はビーコンに会えない日が続く...

コメント

コメントをどうぞ

※メールアドレスとURLの入力は必須ではありません。 入力されたメールアドレスは記事に反映されず、ブログの管理者のみが参照できます。

名前:
メールアドレス:
URL:
コメント:

トラックバック

このエントリのトラックバックURL: http://jh4xsy.asablo.jp/blog/2017/01/14/8323190/tb